Post by somrat6islam222 on Feb 17, 2024 2:22:17 GMT -6
Improvement of the texture of the finishing plaster. Repair of damages caused on the surface. Energy optimization through additional insulating panels. As a precondition, it is necessary to carry out an analysis of the real state of the façade, as well as the agents causing the damage, to establish corrective measures that prevent the reproduction of the damage caused. As the insulation is the support on which the reinforcement layer sits, the façade renovation treatments must be similar to those of a common plaster, with the products used being totally compatible with the nature of the base insulation. The most common pathology is optical/appearance regeneration due to.
Aging or soiling , since it is inherent to the age of the coating, its solution involves a cleaning treatment with hot water under pressure at o max. and bar. Subsequently, a primer is applied according to the absorption of the support and the nature of the final decorative coating that we are going to apply. This pathology normally Phone Number List occurs due to the lack of flight of the ornamental elements of the façade, as well as the non-use of elements to break the water drop, which causes differential washing on the façade, as rainwater drags the dirt deposited on the horizontal elements. Currently there are formulations with low thermoplasticity that cause environmental dirt to remain on the surface and.
Cleaned by rainwater. In the event of an algae and lichen infestation , you must proceed to clean it under the same conditions as the previous pathology, and then apply a biocidal cleaner if necessary. If during the cleaning phase the infestation completely disappears, we would apply a treatment. preventive biocide. Once the cleaning phase has been completed, you must apply a primer and paint the same as in the first case. It is necessary to apply final coatings with high water vapor diffusion, as well as high values of impermeability to rainwater. If you want to change the texture of the decorative plaster, you must first check the mechanical resistance and firmness of the existing.
Aging or soiling , since it is inherent to the age of the coating, its solution involves a cleaning treatment with hot water under pressure at o max. and bar. Subsequently, a primer is applied according to the absorption of the support and the nature of the final decorative coating that we are going to apply. This pathology normally Phone Number List occurs due to the lack of flight of the ornamental elements of the façade, as well as the non-use of elements to break the water drop, which causes differential washing on the façade, as rainwater drags the dirt deposited on the horizontal elements. Currently there are formulations with low thermoplasticity that cause environmental dirt to remain on the surface and.
Cleaned by rainwater. In the event of an algae and lichen infestation , you must proceed to clean it under the same conditions as the previous pathology, and then apply a biocidal cleaner if necessary. If during the cleaning phase the infestation completely disappears, we would apply a treatment. preventive biocide. Once the cleaning phase has been completed, you must apply a primer and paint the same as in the first case. It is necessary to apply final coatings with high water vapor diffusion, as well as high values of impermeability to rainwater. If you want to change the texture of the decorative plaster, you must first check the mechanical resistance and firmness of the existing.